MuxLab 3G-SDI / RS232 over IP Transmitter with PoE
The 3G-SDI / RS232 over IP Extender Kit with PoE allows SDI equipment to be connected up to 330ft (100m) @ 1080p through an IP network. Point-to-Multipoint, and Multipoint-to-Multipoint is possible by connecting several Transmitters and Receivers to the same network. Supports 100’s of Transmitters and Receivers, depending on network bandwidth.
The Transmitters (500756-TX) and Receivers (500756-RX) also support PoE (PD) if used with a PoE (PSE) LAN Switch. In a Point-To-Point network (where no LAN switch is used) distances of up to 390ft (120m) can be achieved over single Cat5e/6. The kit comes with one (1) Transmitter and one (1) Receiver. The IR Emitter and IR Sensor, if required, may be purchased separately for remote control applications.
For the Point-to-Multipoint and Multipoint-to-Multipoint configurations, the Ethernet switch must have Gigabit ports, DHCP Server capability, and support the IGMP communications protocol. MuxLab recommends using the Cisco SG300 Series Managed Switches.
The MuxLab ProDigital Network Controller (500811) is available to simplify the configuration and utilization of the 500756 over an IP network.
Key Features:
- Supports up to 1080p resolutions
- Motion JPEG compression with very low latency
- Supports 100’s of Transmitters and Receivers, depending on network bandwidth
- LAN Switch based configurations support point-to-point, point-to-multipoint and multipoint-to-multipoint
- Extend transmission up to 330ft (100m) over an IP Network (when a LAN Switch is used)
- Extend transmission up to 390ft (120m) in a point-to-point configuration (when a LAN switch is not used)
- Supports RS232 and one way IR transmission for remote control of end devices
- PoE powered
- Compatible with the 500811 Pro Digital Network Controller for software management
- Compatible with 500752, 500753 and 500754 products.
